Child pages
  • PSAM 1.3 First Access
Skip to end of metadata
Go to start of metadata

Once completed the PrivateServer installation, you can connect to the Web console to perform your preliminary setup.

PrivateServer configure its first NIC with the IP address and subnet mask
In order to configure the correct IP address of PrivateServer, you must connect your workstation (through cross-cable or network switch), to PrivateServer and configure the IP address of your workstation to Then you will be able to reach the PrivateServer administrative interface trough the web address

If you can't directly connect to the device or you have no physical access to it (this mostly occur if you are installing on a virtual machine), then you can use your console to configure the network as stated in  PSAM 2.1 Network Configuration

If your server has multiple NIC, please make sure you connect to the correct server NIC (eth0 or the first NIC).

You'll get the login request as shown in fig.1:

Figure 1. login page

To gain access use the default admin login: 

login: admin

At your first access you are asked to change your password:

Fig 1. change password request form


Since the present version any new user is asked to change his/hers password at the first valid access to the web interface

you'll be moved to the welcome page:


Figure 2. Welcome Page


Now you can edit the network configuration following the instructions in PSAM 2.1 Network Configuration.

  • No labels