| Anchor |
|---|
| PSAM_1_3_first_access |
|---|
| PSAM_1_3_first_access |
|---|
|
Once completed the
installation, you can connect to the
Web console to perform your preliminary setup.
configure its first NIC with the IP address
10.0.0.100 and subnet mask
255.255.255.0.
In order to configure the correct IP address of
, you must connect your workstation (through cross-cable or network switch), to
and configure the IP address of your workstation to 10.0.0.200/255.255.255.0. Then you will be able to reach the
administrative interface trough the web address
https://10.0.0.100.
| Tip |
|---|
| If you can't directly connect to the device or you have no physical access to it (this mostly occur if you are installing on a virtual machine), then you can use your console to configure the network as stated in PSAM 2.1 Network Configuration |
| Warning |
|---|
If your server has multiple NIC, please make sure you connect to the correct server NIC (eth0 or the first NIC). |
You'll get the login request as shown in fig.1:
| Subtitle |
|---|
| Prefix | figure |
|---|
| SubtitleText | login page |
|---|
| AnchorName | login_page |
|---|
|
 |
To gain access use the default admin login:
login: admin
At your first access you are asked to change your password:
| Subtitle |
|---|
| Prefix | figure |
|---|
| SubtitleText | change password request form |
|---|
| AnchorName | 1st access change password |
|---|
|
|
you'll be moved to the welcome page:
| Subtitle |
|---|
| Prefix | figure |
|---|
| SubtitleText | Welcome Page |
|---|
| AnchorName | welcome_page |
|---|
|
|
Now you can edit the network configuration following the instructions in 2.1 Network Configuration.